Over time my tool length sensor has become pitted in the very center of the hard plastic pad, from use over the life of this machine. I am wondering if it would have any effect on the accuracy of the sensor if I were to sand the surface of the sensor
thank you.
re-surface tool length sensor.
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Evan Corey
- New Member
- Posts: 10
- Joined: Thu, Feb 28 2013, 12:40PM
- Company Name: Kitchen Creation
- Country: CANADA
-
Richard White
- New Member
- Posts: 11
- Joined: Wed, May 06 2015, 6:46AM
- Company Name: TaylorMade Systems
- Country: UNITED STATES
Re: re-surface tool length sensor.
You can do that, I just used .2 thick nylon sheet and made another one...OR you can request a replacement from Thermwood, they have them.
