door/draw front deisgner

[t w fortier]

in the above designer, I can not edit the 'door name' or 'directory' boxes to save my door.
Is there someplace I am to go first before I got to the door/draw front designer so I can save my doors?

[Clint Buechlein]

When you open the designer, first select either door or drawer at the top. You then select your source whether it be Slab, MDF, etc. Then click the blue text that reads "Standard", and then click one of the standard doors. Make your changes in material, costing, etc (if any) and click save. When the dialog box opens after clicking save, clear the text where it says "Standard" and start typing in a name for the a new directory. Do the same for the name of the door or drawer. Clicking save will save it in the new directory you named with the name you stated.

[t w fortier]

I found where I went wrong...