Saint Charles 2 1/4 Molding

Paul Huff · Post by **Paul Huff** » Mon, Jan 09 2006, 7:56PM

I used a 2 3/4 peice to cut this out of, notice the quarter on each side. This is probably why this would not cut but I was trying to get the CNC to outline the trim.

I tried to add the .X_t. File I used to create this but that extension can not be posted here.

DanEpps · Post by **DanEpps** » Mon, Jan 09 2006, 9:03PM

Paul

You can zip any file type that can't be directly uploaded. Zip files will always upload unless they are too large, of course.