Is it possible?

[Donald Thomson]

Is it possible to set M&T depths different for left and right side of a cabinet? Sometimes I would like to have a .375" deep mortise on one side and a .5" deep mortise on the other side.

Thanks!

Don

[Leo Graywacz]

Just went into the editor and it doesn't look like it's possible. There seems to be one parameter for depth, nothing to indicate right vs left.

[Scott Marshburn]

I am able to alter the dado depths on a deck for full dados by setting the dado depth on the deck too.5".Then setting the left inset too.125 however, for some reason this method will not work for blind dadoes.

[Donald Thomson]

Thanks guys. That's what I was afraid of. Maybe the programmers can figure out if there is a way to do this?