I am having a problem in Custom Layout with placing countertops on base cabinets. On some cabinets it places the countertop right on the cabinet where it should be, but on other cabinets the countertops are floating an inch or so above the cabinet. I have reviewed all the parameters and can't find any differences between the cabinets that might cause this. Is there a setting somewhere for where a countertop is placed in relation to the cabinet? The problem doesn't seem to be in the countertop material because the same material will work fine on one cabinet but not another.
Thanks for any help.
Countertop Height
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- New Member
- Posts: 9
- Joined: Fri, Dec 23 2005, 9:51AM
- Location: Oshkosh, WI
-
- Guru Member
- Posts: 837
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Re: Countertop Height
Mark, Could you post the esj file so we can take a look?
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
-
- New Member
- Posts: 9
- Joined: Fri, Dec 23 2005, 9:51AM
- Location: Oshkosh, WI
Re: Countertop Height
I actually figured it out. It had to do with the construction parameters on those particular cabinets. I wanted the sides to come down and be flush with the bottoms of the face frames, so I had a negative bottom inset on the cabinet sides, which apparently pushed them down into the floor or something. So instead I zeroed out the bottom inset on the sides and put an inset on the bottom of the deck which had the intended result without the issues.