Rear Operation Sequence and Cancellation Option on MTR21 Machine
Posted: Tue, Jun 23 2026, 7:02AM
Dear Sir/Madam,
While performing rear operations in cabinet drawings, the machine sometimes moves in a way that is different from the intended process.
Machine number: MTR21115E0126
On our previous machine, the rear operation was prompted for confirmation at the end of the program. This allowed us to complete the job without performing the rear operation whenever it was not required.
However, on the MTR21 machine, we would like to know:
Is it possible to cancel the rear operation directly from the machine?
Is it possible to set the rear operation to be performed as the last step of the program?
Are there any settings or recommendations that would allow us to achieve this?
We would appreciate your support and guidance on this matter.
Kind regards,
Kadri Demirdogen
Profil İçmimarlık
While performing rear operations in cabinet drawings, the machine sometimes moves in a way that is different from the intended process.
Machine number: MTR21115E0126
On our previous machine, the rear operation was prompted for confirmation at the end of the program. This allowed us to complete the job without performing the rear operation whenever it was not required.
However, on the MTR21 machine, we would like to know:
Is it possible to cancel the rear operation directly from the machine?
Is it possible to set the rear operation to be performed as the last step of the program?
Are there any settings or recommendations that would allow us to achieve this?
We would appreciate your support and guidance on this matter.
Kind regards,
Kadri Demirdogen
Profil İçmimarlık