today my 40hp table vaccum was making a very loud grinding noise and i took a look at it and the turbine is binding up/grinding in the turbine housing. just trying to see if anyone has heard of this before and how to fix it? right now i am looking at it and it is fine until i put the cover on the last side. it looks to me that the bearings hold the blades in the turbine in the right place. I believe that there is to much play in the shaft b/c i can get it to stop grinding until i put the last cover on it. just need to know if there is an adjustment i am missing. thanks in advance.
Arthur
Please help......binding up
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Arthur Ledet
- Junior Member
- Posts: 34
- Joined: Sat, Jan 14 2006, 3:32PM
- Location: New Orleans
Please help......binding up
Cabinets and Countertops of Louisiana
(504)464-7039
(504)464-7039
-
Jason Susnjara
- Thermwood Team
- Posts: 1653
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
