conestoga doors not routing profile on top edge.

Brian Bauer · Post by **Brian Bauer** » Mon, Jan 15 2007, 8:58PM

Take a look at this first time I have seen this.
Doors not routing edge detail on top edge.

Brian Bauer

Brian Shannon · Post by **Brian Shannon** » Mon, Jan 15 2007, 11:37PM

Brian,

I messed with this cabinet for a while. That door is giving me all sorts of edge profile problems. Cannot rebuild bottom rail. Other Calistoga doors seem O.K.. Odd...

Brian

Michael Yeargain · Post by **Michael Yeargain** » Tue, Jan 16 2007, 12:33PM

I mentioned in an earlier post there was an issue with some of the doors. It seems to have appeared in the latest build. I think it was with the stile and rail doors. mitered doors didn't have this problem.

Brian Bauer · Post by **Brian Bauer** » Tue, Jan 16 2007, 1:40PM

I was just wondering it doesn't look so good on the presentations.
Maybe something else for the programmers to look at

.

Keep up the good fight busy programmers, Any word yet on the cutlist summary yet?Just finished a job and looked at it whoa, Little shy on the materials.

Brian Bauer

Michael Yeargain · Post by **Michael Yeargain** » Fri, Jan 19 2007, 12:11PM

Brian,

I'm sure they are solving this in the next build/version. There has been suggestions made to calculate board foot instead of the way we all see it now. Inches.

Thermwood / eCabinet Systems

conestoga doors not routing profile on top edge.

conestoga doors not routing profile on top edge.