No doors in cut list

Francis Gaudreau · Post by **Francis Gaudreau** » Thu, Feb 22 2007, 9:18AM

Hi folks,
the last few jobs we've drawn we have been experiencing some weird display in the cut list.
We've drawn our cabinets, put Conestoga CRP-10 doors, for some reason they don't show up in the cut list! Not even at the end where normally the whole list of doors is listed.
Anyone with an anwser to this.
Thanks.

DanEpps · Post by **DanEpps** » Thu, Feb 22 2007, 9:22AM

Make sure you have Alternate Source checked for the doors. If not they will only show on the Buy List.

Francis Gaudreau · Post by **Francis Gaudreau** » Thu, Feb 22 2007, 9:28AM

Problem solved.
Thank you Dan.

Thermwood / eCabinet Systems

No doors in cut list

No doors in cut list