Hey hows it going?
Compatability for THM version 6.1.4.0 and greater for dovetail, puzzle joint, and kd/rta construction methods (ADDED)
where do i find info about getting 6.1.4.0? How much does it cost to upgrade? how much better is it than 5.05? Can i upgrade easy from 5.05 to 6.1.4.0?
Thanks
Thom Davies
RN 5.30
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Thom Davies
- Guru Member
- Posts: 530
- Joined: Tue, May 17 2005, 6:44PM
- Company Name: Dawn Group
- Country: NEW ZEALAND
- Location: Christchurch New Zealand
-
Ryan Hochgesang
Thom,
You will need to contact Thermwood (1800 221 3865) and ask for the Retrofit/Upgrade dept. One of the two gentlemen in this dept. will be able to give you a quote on what it would cost to upgrade to a new version of THM software. I do know that your looking at some hardware changes in the control cabinet in order to go from THM V5.05 to 6.0+. There were many changes that took place due to the fact we switched from a WIN2K operating system to WIN XP at this point.
You will need to contact Thermwood (1800 221 3865) and ask for the Retrofit/Upgrade dept. One of the two gentlemen in this dept. will be able to give you a quote on what it would cost to upgrade to a new version of THM software. I do know that your looking at some hardware changes in the control cabinet in order to go from THM V5.05 to 6.0+. There were many changes that took place due to the fact we switched from a WIN2K operating system to WIN XP at this point.
