A customer seen this in a HD book would like me to make it.
I started it today at 7:00 in Punch ViaCad I truned it in to STL Files (97 STL) I am going to try to make it in E-Cabinets
113" x 34-1/2" x 28-1/2"D
2-Bow Vanity
Moderators: Jason Susnjara, Clint Buechlein, Jason Susnjara, Clint Buechlein
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
2-Bow Vanity
2-bow Vanity
A customer seen this in a HD book would like me to make it.
I started it today at 7:00 in Punch ViaCad I truned it in to STL Files (97 STL) I am going to try to make it in E-Cabinets
113" x 34-1/2" x 28-1/2"D
A customer seen this in a HD book would like me to make it.
I started it today at 7:00 in Punch ViaCad I truned it in to STL Files (97 STL) I am going to try to make it in E-Cabinets
113" x 34-1/2" x 28-1/2"D
- Attachments
-
- Vanity 2-Bow.jpg (68.77 KiB) Viewed 4030 times
-
- 2-Bow Vanity 113 x 34. x 28.5.jpg (48.19 KiB) Viewed 4028 times