Thermwood / eCabinet Systems

Hi Brad,

Thanks that is greatly appreciated.

Gerry

Hi,
I will attempt to get it changed to incremental.
Thanks everyone,
Gerry

Hi,

I should have mentioned we are running this on a 2007 CS45 with 6.1.6.5 control.

Thanks,
Gerry

Hello everyone,

I am trying to get a Post P working that outputs Arcs but the router seems to cut all over the place when I run the code that is produced. Could some one please take a look at the code and see what is wrong with it. I have attached the code and the Post P that produced it.

Thanks ...

Hi,

I have worked through this trying all the suggestions. I get good results doing conventional feed with the G07F0 code. I have modified the Post P to insert this command and it all seems to work well. I have not got the Post P to output arcs yet but will pursue that as time permits.

Thanks to ...

Hi Scott,

It has been a while since I tried but I did try to use the KD option to do this. I think it allows for a given number of fasteners and max spacing. We have a pattern set up for the common depths we use and just use the boring machine to do the vertical boring on the rest of them.

It is a ...

Kerry,

I would be interested in any solutions you might have for this problem. Would you be willing to share your solution on the forum?

Thanks,
Gerry

Hi,

We use both doweled & dowel & confirmat. Ecabinets does not support 32mm dowel drilling but you can make it work. It would be great if there was an option to add 32mm hole pattern to sides & patricians then go in and delete the holes you don't need. I think this has been on the to do list for ...

Hi,

I have been away from the shop so am a bit late responding.

Brad thanks I will try that. I have not tested any of the suggested mods yet but will post back with results when I have had a chance to do so.

Thanks,
Gerry

Hi Scott,
I'll give all your suggestions a try keep you posted on the results.

Thanks,
Gerry

Hello Scott,

I did a few test cuts
1. a interpolated hole drawn at 1.05" cuts at 1.025" with .5" cutter
2. a slot drawn at .375 wide cuts at .3615" with .25" cutter
3. a slot drawn at .25" wide cuts at .247" with .25" cutter

This is with the G07F5 in.

I have attached the NC file so you can ...

Hi Scott,

I will give that a try.

Thanks,
Gerry

Hi Everyone,

I am doing a job for a customer that has prepared the files with Aspire. The files require slots & holes cut to an exact size and I find the sizes are not coming out correctly. Interpolated holes are under size by .005" to .01" and the same with the slots. Is there a calibration I can ...

Hi,

It looks like only the black one has been discontinued.

Thanks for that Forrest,
Gerry

Hi Josh,

We have used them in the past but I just looked for the part online & I see the flush version in 16mm has been discontinued. I guess I will need to find an alternative for the 16mm. I'll give the minifix a look.

We mostly use them on 19mm lock dado closet parts so it is not something I do ...