Sets in Constraints editor

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Mark McCallum
Guru Member
Posts: 297
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Sets in Constraints editor

Postby Mark McCallum » Mon, Apr 29 2019, 5:56PM

I had a quick dig around and couldn't find anything.
So I thought I'd ask the collective Ecabs mind.

Once you create a set in the Constraints Manager, can you uncreate it to re-edit? I was trying to change diameters and don't think I can ungroup it?
Also can you copy and paste sets within the CM, I tried a few ways but I don't think so. Just looking for confirmation?

Geometry sets.JPG


Any feed back appreciated.
Thanks
Mark

Clint Buechlein
Thermwood Team
Posts: 351
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp
Country: UNITED STATES

Re: Sets in Constraints editor

Postby Clint Buechlein » Tue, Apr 30 2019, 7:08PM

Mark,

To undo a Set, choose the delete like you would to do a dimension and then select the set icon (the green S with the green circle on it). That will ungroup them from a set, you can make your changes and recreate the set.

-Clint-

Mark McCallum
Guru Member
Posts: 297
Joined: Thu, Jun 16 2005, 7:53PM
Location: Sydney Aust

Re: Sets in Constraints editor

Postby Mark McCallum » Tue, Apr 30 2019, 10:44PM

Thanks Clint.
That makes sense.


Return to “eCabinet Systems Software”

Who is online

Users browsing this forum: No registered users and 12 guests