Rolling Nest 4.64 errors

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Rich Kasten

Nick M Singer
Guru Member
Posts: 828
Joined: Fri, Jun 17 2005, 12:23AM
Location: South Africa

Rolling Nest 4.64 errors

Postby Nick M Singer » Sun, Aug 14 2005, 12:56AM

I am using Rolling Nest 4.64 and have suddenly picked up the following problems. The machine is skipping some operations, I though that these were originally resrticted to a few outlines in the g900 quadrant but are actually random and range from not cutting one side of an item to not coming full round to clean up the in-ramp. I was also cutting a series of 75mm holes yesterday and to prevent the formation of possibly airborn discs I set the pocket settings to zig-zag. What the machine does is cut one hole with a zig-zag path and then the next with a spiral.

Ryan Hochgesang
Thermwood Team
Posts: 681
Joined: Wed, May 18 2005, 8:41AM
Location: Thermwood

Postby Ryan Hochgesang » Mon, Aug 15 2005, 10:38AM

Hi Nick,

I've received your machine files along with the .twd that I had requested on Friday the 12th. We are looking into your situation here and will get back with you asap.
Ryan Hochgesang
Software Support


Return to “Thermwood 3-Axis Machinery”

Who is online

Users browsing this forum: No registered users and 3 guests