When trying to nest a job in eCabinets I am getting "Encountered an Improper Argument" message followed by a frozen program.
Any help fellows?
Thanks in advance.
SD
"Encountered an Improper Argument" ???
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 82
- Joined: Wed, May 24 2006, 1:52PM
- Location: Beech Island, SC
- Contact:
-
- Junior Member
- Posts: 82
- Joined: Wed, May 24 2006, 1:52PM
- Location: Beech Island, SC
- Contact:
Re: "Encountered an Improper Argument" ???
Fixed. Well, could not figure out any cause but did find the cabinet that was causing the problem by taking one out at a time and then re-nesting.
-
- Thermwood Team
- Posts: 1740
- Joined: Tue, May 17 2005, 12:44PM
- Company Name: Thermwood Corporation
- Location: Thermwood Corp: Dale, Indiana
- Contact:
Re: "Encountered an Improper Argument" ???
Steve,
Please post the job that was causing the problem and we will try to reproduce it here and maybe resolve the issue. (If you cannot post the job, send it to cabinets@thermwood.com Attn: Scott)
Please post the job that was causing the problem and we will try to reproduce it here and maybe resolve the issue. (If you cannot post the job, send it to cabinets@thermwood.com Attn: Scott)
Regards,
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
Scott Vaal
-Thermwood/eCabinet Systems-
Dell Precision / Xeon E3-1240 / 8GB RAM /NVIDIA Quadro K2000
-
- Junior Member
- Posts: 82
- Joined: Wed, May 24 2006, 1:52PM
- Location: Beech Island, SC
- Contact:
Re: "Encountered an Improper Argument" ???
Thanks Scott but I deleted the little demon cabinet that was causing the issue.