Thermwood / eCabinet Systems

I too am getting crashing incidents. I can't load any of my draw units. It just hangs and white screens.
If i can get it to throw an error it says ig4icd32.dll which I've traced back on these forums to be a graphics driver issue (the graphics are integrated Intel R33/R31). Tried updating the driver ...

Search.
http://www.thermwood.com/forums/search. ... rds=vcarve
We run a CS40 you'll find a good post processor in one of these threads.

Try looking at

http://www.thermwood.com/forums/viewtop ... rve#p69489

Sounds like a market opening for a knowledgeable tools salesperson over there.

Not really, you can always set the fixed height of the draw in the Min Height Inc.

You can make it however you want. However, two units is easier to assemble, easier to transport and deliver, easier to price.

We too have had errors pop up on start up ( and more ). Turned out to be a dicky power supply. I'm sure Dean's got this one covered with his diagnosis, but a faulty PSU can do some really weird things to your computer.

......And...... we got very, very close. Really close. More shelf holes in the ends, but none for the backs of cabinets (or no extra method to enable this that I can see). Oh well maybe next time

Agreed. I've asked for this a few times.

May or may not be related. But does this thread help?

http://www.thermwood.com/forums/viewtop ... &hilit=dxf

Noy a very good explanation, but the pics will tell the story. Can anyone tell me why these spindles keep dropping down and why aren't they user serviceable (that I can see). This would be the third or fourth time this has happened. The internal drill keeps dropping down over time and then gets down ...

Further to that Neville, when you say the holes are 2 to 4mm out, do you mean up or down or forwards or backwards? Or a combination of those? I can send you my drilling patterns and draw boxes if you like.

Hi Neville, I use Harn Impaz and Triomax all the time without any drilling issues. What are you REALLY doing?

Why when we nest material in Ecabs, it never ends up as being as good as the nest the controller does. I.E. the nest on ecabs will always show more material used than what it will actually nest on the controller. Very annoying when it might run just into say 6 sheets and we then have to go to the ...

We tried LDF. It lets too much suction through and parts move everywhere. Normal MDF with just a minimal flycut taken off top and bottom to take off the shine works fine.

To make things a little quicker, when you make a draw box that has metal sides like the grass ones, you can set the sides of the draw box in, for example the blum ones I use have to be set in 15.5 mm from each side of the opening. In the draw box construction settings, put this allowance in for the ...