Thank you Rick for your answer. I know now, not to try to alleviate this in eCabinets Systems software, and will wait till I have a link and then check on the cut order/optimization at that time.
Doug
Search found 2 matches
- Wed, May 13 2009, 12:56PM
- Forum: eCabinet Systems Software
- Topic: Nest Diagrams - Cut order?
- Replies: 3
- Views: 3141
- Wed, May 13 2009, 10:02AM
- Forum: eCabinet Systems Software
- Topic: Nest Diagrams - Cut order?
- Replies: 3
- Views: 3141
Nest Diagrams - Cut order?
Good morning,
I would like to give you a brief introduction, as I am a new poster. I'm a cabinetmaker in Raleigh NC. I have a Shopbot, and thought it would behoove me to learn the eCabinets Systems software with the introduction of the new Thermwood - Shopbot link. Note: I have not purchased the ...
I would like to give you a brief introduction, as I am a new poster. I'm a cabinetmaker in Raleigh NC. I have a Shopbot, and thought it would behoove me to learn the eCabinets Systems software with the introduction of the new Thermwood - Shopbot link. Note: I have not purchased the ...
