Thermwood / eCabinet Systems

To create a pocket, it needs to be a polyline. When you draw a circle in autocad (at least) it is not a polyline. You need to use pedit (in autocad) to convert that circle into a polyline.
CN will treat all circles as a drill operation only.

Hey guys,
installed CN5.75 yesterday, and this morning nested a job and all barcode label for offcuts were showing a -1 as the number. Now the offcut are numbered properly and showing up in the added sheets correctly. just not printing the barcode properly.

Problem got resolved by reverting back ...

30 views and no reply.

Gotta love it....

Wondering why when I load an Ecab job in CN, the assigned B# of the cabinets are not in numerical order. They are all over the place. Used to be in order at some point but changed with CN updates which one I don't know.

Is it a setting that I changed at one point, I don't know, all I know it is ...

Gerry,

Im a shop in Ontario, using the same product as you, we use s411 from panolam. Since we had our machine, i've cut well over 50 lifts of this stuff. Played with different tools, speeds and even different boards and I still have that problem.
Could tell you that the columbia melamine is no ...

Stupid logic, have a 3/8 tool, it should be able to do a few pass to make it to 3/4. guess my outline tool will have to do, dont have a 1/2 downcut

Thermwood, pls have a look, I'm stumped

Can you look at these files and figure out what going on, think it’s the first time I use full dado in ecab, and when nesting CN is giving me can find appropriate tool for operation.

The TWD enclosed is just a test piece that I want to run to check tolerance ...

Had this problem several times, first time did the same thing as Kerri, piece of scrap feel to the side and when gantry moved forward it lifted the pop up pin and then crash (model 43).

head was out of tram at this point, 400$ service call was put in, tech guy used the tram bar and dial indicator ...

Did a repair on the control nesting while waiting for a reply and that works fine.

Thank you

Loaded a job in control nesting and when I press X or Y to nest, it gives me an error: Urecognized database format \rolling nest\Result.mdb

Help, need to cut right away....

Thanks
Dave

Guys...
Workaround: Nest with off falls on and print labels. Turn off the off falls cut feature. Cut as normal. You have labels, you have no off fall trim. Life is good.

Sorry Gary (thanks for the tip), life is not good. Just one more work around to do! I have enough issues with the amount of ...

Steve , the current printer that came with our CS43 was a Pixma (cannon) 2700. Small regular consumer type printer> Not Happy with it, It's a plain ink jet printer, with numerous paper jam errors.got machine in april and this is the second printer from thermwood. Constantly have to clean the rollers ...

Daniel, Guess that logic is right, tool would be cutting in board, but it is not. It's roughly 1/4" past. Tools are setup ok, cause I cut from CN with no issues. Will Try again later this morning to double check or replicate the problem on a different profiled piece. Currently have a couple rush ...

Ok, so I have done in the past a few modelled run thru CN without any major issues.

Figured out the difference between custom and profiled job in the PM setting, realized the limitation with PM and CN, and this bring us to my current problem.

I have no problems running a part thru CN, but if I ...

Josh,
The way I understand it, ih that you cannot rout a blind dado in one pass, so the cutter diameter is to close to the dado, if rour tool was sharpen and be at 0.237 or under it would cut ok.

Easy fix, increase your tenon at 55%

Dave