Thermwood / eCabinet Systems

Thom, yes I have a model 40. I did not install this program myself, the guys that work on my system and network did. It works great. Sorry I can't help with info on the download.
Grady

We use this: Ultra VNC Viewer
http://www.uvnc.com/

Dave,
We don't actually throw them away. We use them for decks in crates we ship in. Let us know know what you come up with for a time on your fly cutting program. Mine my not be optimized.

Damon,
We have a hard time getting 5'X10' also. I just use 4'X8' and then cut fillers for the extra. We ...

My fly cutting program runs 16 minutes and 19 seconds.

Standard cnc time rate is $ 125.00 per hour or $ .034 per second, so just in machine time I figure it cost me $ 33.28 to fly cut the table. I can get a sheet of .25 MDF off the rack without my forklift. We cut 100's of small (6"X6") parts every ...

Damon,

Don't know the answer to your problem, but here is what we have started doing. I have not used my fly cutter in about a year. We have a 5'X10' table. We use a sheet of .25" MDF as a waste board, one full sheet where we cut mainly and two outside fill pieces. When the full sheet gets too cut ...

Damon,

We actually cut into the corner of our table one time (the alluminum part) and all it did was destroy the inserts on the flycutter. No actual damage to the rest of the tool.

Grady

Mark,

I think I may have this file somewhere for .75\" material as a MasterCam 9 file. If you want it, I could convert it to a dwg file. Let me know.

Grady Robertson

http://www.woodgraphix.com
grady@woodgraphix.com
806-535-8234

Jason,

Thanks for the info. I am actually interested in trying the finishes on some MDF carvings so the entire piece would have the \"skin\" removed. Would I just need to coat the entire piece with the edge filler and then proceed with the standard schedule?

Grady

Has anyone tried the furniture finishes on MDF? I seem to remember something on this but couldn't find anything.

Thanks,
Grady
http://www.woodgraphix.com
[/url]

Jim,

I would be happy to look at your relief and give you a quote. Give me a call or email the picture of what you need.

Grady Robertson
http://www.woodgraphix.com
806-535-8234

Henry,

We would also be interested in this project. We have a Thermwood CNC router, one CNC laser with a 4' X 8' table and one smaller laser. Check out our work at http://www.woodgraphix.com

Grady Robertson
806-535-8234
877-863-3935 Toll free
grady @ woodgraphix.com

Nick,

We have a model 40, 5' X 10' table, 18HP router, 40HP Trivani pump, typewriter tool changer. We run MasterCam, ArtCam and ecabinets. The link to the machine is seamless. I like the fact that when I encounter a problem, I just make one call to Thermwood and get it taken care of.

I was like ...