Flip Operations Fence

Michael Kowalczyk · Post by **Michael Kowalczyk** » Mon, May 08 2006, 1:21PM

Thanks Bill for the info.

Bill Rutherford · Post by **Bill Rutherford** » Mon, May 08 2006, 1:35PM

Jason,
Thanks for the update, you put a smile on my operators face

Brian Shannon · Post by **Brian Shannon** » Mon, May 08 2006, 10:36PM

I am using a Busch 15HP pump. About a year ago I started using a wasteboard. It does hold the parts better. I have a 5 X 8 table. I thinned down some wood glue and brushed it on the edges and 6\" of the surface on each side(to seal from vacuum leakage). I tack on a 4 x 8 mdf wasteboard. Recently, I had to cut some 1\" MDF. Just for kicks, I layed a 2' x 2' pc. of Melamine on top of the 1' MDF. I think the vacuum held even stronger through all of this(3/4\"+1/4\"+ 1\"). Incredible holding power.

Bill Rutherford · Post by **Bill Rutherford** » Wed, Jun 28 2006, 9:25AM

Jason,
I see a new version of Rolling Nest is out and I do not see the change for flip ops on wasteboards listed. Was it included? If not then could you please direct me to the \"official\" complaint form??

(After all, you promised!!!!)

Post by **Jason Susnjara** » Thu, Jun 29 2006, 7:54AM

Hi Bill,

I will ask the programmers about this.

thanks,

Brad McIntosh · Post by **Brad McIntosh** » Fri, Jul 07 2006, 2:25PM

Looks like Jason has some pull with the programmers! <smile>

7/05/06 - The latest version of Control Nesting is v4.94.

* KD operations not being done as drill operation in some cases (FIXED)
* Wasteboard option for flip ops in settings (ADDED)
* Ability to add a macro at header and/or footer for each sheet (ADDED)
* Changed Room# to Job name in printed sheet (ADDED)

Thermwood / eCabinet Systems

Flip Operations Fence