this is so old

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

this is so old

Post by Jeff Norris »

wonder what would happen if i ran this program
Attachments
bad nest.jpg
bad nest.jpg (68.17 KiB) Viewed 9738 times
more bad nests 2.jpg
more bad nests 2.jpg (71.64 KiB) Viewed 9738 times
Top
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

more
Attachments
more bad nests 3.jpg
more bad nests 3.jpg (81.83 KiB) Viewed 9737 times
Top
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

spend another hour of my life, delete all the edge banding and now it will nest. this is great!
Top
Forrest Chapman
eCabinets Beta Tester
Posts: 1260
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:
Contact Forrest Chapman

Post by Forrest Chapman »

Jeff,

I found most of the time these are just graphic issues. Did you write the code and check it?

Forrest
Top
Jeff Norris
Guru Member
Posts: 321
Joined: Fri, May 20 2005, 1:44AM

Post by Jeff Norris »

this is no graphic issue just ecabinets
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”