Has anyone had a problem with an M4 being inserted behind a tool call instead of the M3, when using an Ecab twd file through RN?
It happened last night on the first tool call. T5M4 and it spun cntrclckws tearing up a dado. I checked the tool settings and none of them had a check on the reverse spindle option. I checked all the other tool calls and they all had the correct M3 after it.
I was running RN ver 4.94 and then I upgraded only to RN ver 5.01 because I heard 5.02 had caused some other conflict.
Thanks,
Rotation problem
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Michael Kowalczyk
- eCabinets Beta Tester
- Posts: 284
- Joined: Tue, May 10 2005, 11:35AM
- Location: Houston, Texas
Rotation problem
Michael Kowalczyk, GM
HP-Elite Quad Core Q6700-4 MB ram, Nvidia GeForce 512 MB Dual HP 22" flat panels, Windows 7 ultimate 64bit SP1
HP-Elite Quad Core Q6700-4 MB ram, Nvidia GeForce 512 MB Dual HP 22" flat panels, Windows 7 ultimate 64bit SP1
-
Jason Susnjara
- Thermwood Team
- Posts: 1653
- Joined: Tue, May 10 2005, 1:26PM
- Location: Thermwood
- Contact:
Hi Michael,
Thanks for the files and we are looking into this. I have not seen this problem before. Can you please email me your machine.ini and tools.thm to cabinets@thermwood.com
thanks,
Thanks for the files and we are looking into this. I have not seen this problem before. Can you please email me your machine.ini and tools.thm to cabinets@thermwood.com
thanks,
