bar design

Craig Day · Post by **Craig Day** » Sat, Oct 07 2006, 3:57PM

I'm looking for some design ideas for basement bars. Pictures or web sites could be helpfull. I will then modify to my likings. Thank you.

Brian Shannon · Post by **Brian Shannon** » Sat, Oct 07 2006, 11:35PM

Craig,

I am just starting to work on a 20' bar that I may do in modular units. This is all I have so far but it may give you ideas.

Brian

Rick Palechuk · Post by **Rick Palechuk** » Sun, Oct 08 2006, 12:30AM

Hey Brian, what's your time spent on this so far? I took it into the CE and it's quite interesting how you have constructed this. Talk about thinking outside the box. You should post this when your done.

Brian Shannon · Post by **Brian Shannon** » Sun, Oct 08 2006, 1:05AM

Rick,

This is pretty rough still. I have maybe an hour or so into it. The bar owner spec'd the chase for the beverage supply tubes. I still have to design all of the back bar stuff. It really is just boxes with stuff applied onto them. The good(or bad)news is the bar is a half block away from my shop. It would be a fun project if I had time for it. I should not complain but I am a two man shop and the work just keeps comming. I don't want to hire more(as if there were more skilled workers?). Work, work, work.....

Craig Day · Post by **Craig Day** » Sun, Oct 08 2006, 8:07AM

Brian,

Thank you for the picture. Rick mentioned he took it into CE. How did he do this and will it alow customizing? I'm new to the software. Thanks

Mike Seisser · Post by **Mike Seisser** » Sun, Oct 08 2006, 9:20AM

Here's a few I've worked on in the past few years, hope this helps.

Regards,

Mike

Rick Palechuk · Post by **Rick Palechuk** » Sun, Oct 08 2006, 11:06AM

Hey Craig, download the ESA file to desktop then right click start, open explore, program files, thermwood, e-cabinet systems, assemblies, then shrink window half size and drag file from desktop to assemblies, close window, open e-cabs, cab editor , click load item, assemblies and click on the file. HTH

Brian Shannon · Post by **Brian Shannon** » Sun, Oct 08 2006, 6:36PM

This is an assembly of two cabinets

Mike Bowers · Post by **Mike Bowers** » Thu, Oct 12 2006, 7:05PM

Rick Palechuk wrote:Hey Craig,
download the ESA file to desktop
then right click start, open explore, program files, thermwood, e-cabinet systems, assemblies, then shrink window half size and drag file from desktop to assemblies, close window, open e-cabs, cab editor , click load item, assemblies and click on the file. HTH

Instead of desktop, save as & follow Ricks steps but take it right to proper folder. I used to do it that way & I ended up with excessive cluter on desktop because I never deleted the Icon.
Mike

Thermwood / eCabinet Systems

bar design

bar design

Re: