Our machine was estopped this afternoon, when we tried to mc reset it the table moves in the wrong direction to go home. Looking at the table the normal home position for the X axis is to the left. our table runs to the right till it runs out of screw and then emergency stops.
Any ideas? Tried all the usual, stop restart machine, power down etc etc
Table movement problem
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Glenn Van Reason
- Guru Member
- Posts: 459
- Joined: Tue, May 17 2005, 4:00PM
- Company Name: TBA
- Country: AUSTRALIA
- Location: ORANGE NSW AUSTRALIA every now and then between trips lol
Table movement problem
This message made from recycled electrons.
-
Glenn Van Reason
- Guru Member
- Posts: 459
- Joined: Tue, May 17 2005, 4:00PM
- Company Name: TBA
- Country: AUSTRALIA
- Location: ORANGE NSW AUSTRALIA every now and then between trips lol
-
Brian Shannon
- eCabinets Beta Tester
- Posts: 979
- Joined: Thu, May 19 2005, 10:50PM
- Location: Los Alamos, CA