Rolling Nest OffFall Problem

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Rolling Nest OffFall Problem

Post by Brian Shannon »

RN tried to save a 1/8' x 38\" section of the OffFall shown. The section(strip) is at the bottom-right. My OffFall is set to 14\".


Brian
Top
User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Post by Brian Shannon »

Here's a .jpg Notice point 6.
Top
User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Post by Brian Shannon »

I guess that's points 5 & 6
Top
Mark Hesketh
Guru Member
Posts: 366
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Post by Mark Hesketh »

i get this kind of thing all the time. most often it breaks that thin leg off while it is trying to save it. since it will never nest anything in that little piece anyways, i just break it off and ignore it. just one of those little things that makes me shake my head at the machine.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”