Rolling Nest Problem

[Brian Shannon]

I'm having problems nesting this box with two 14\" cutouts. I just upgraded my control to 5.05 build 9, RN 5.05 w/ PM. Box was created in eCabinets V5.10. The .twd was created in V5.11. It seems to nest good in eCabinets. Any ideas?



Brian

[Nick M Singer]

Hi Brian I just nested this in V5.04 and it went just fine. Maybe it has something to do with your RN settings

[Brian Shannon]

I just tried it in RN 5.07 and got the same results. I don't know what settings would give me this. I've converted to .jpg

[Nick M Singer]

Give me a screen shot of your RN settings

[Brian Shannon]

Here's a screen shot. Do you see anything?

[Brian Shannon]

I just ran the beginning of the program and the circles are correct. It must be a graphic problem.

[Nick M Singer]

Hi Brian Sorry about the huge lag in comms Where is CA? We must be about 10 hours ahead of you guys if you are in California. Its Sunday afternoon here I will check it out tomorrow when I crank up my Thermwood. My nesting looked very different to yours as you say it may be a graphics issue, Most often I get wierd graphics when printing nesting sheets for curved objects.

[Brian Shannon]

Yes, I'm in California. Sunny California. 75 degrees f. today! The speaker box is done and took almost 2 sheets of 1 inch MDF. Very heavy!




Brian

[Nick M Singer]

Glad it worked out Brian Must be for some pretty heavy sounds. I think the display problem is just another one of those Thermwood things that make you go MMMMMMM!!!!!