I have a room layout that with wich I am happy with the lighting and layout. However, when printed it is a little too dark. Hoew can I lighten it up?
Thanks,
Joe
brightness when printing presentation image
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Joe Murphy
- Junior Member
- Posts: 73
- Joined: Wed, Nov 30 2005, 9:26PM
brightness when printing presentation image
Joseph Murphy
President
Highland Woodworking
Nelsonville, NY
President
Highland Woodworking
Nelsonville, NY
-
Kerry Fullington
- Wizard Member
- Posts: 4763
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Joe,
I like to save the images as jpegs then open them using the image control (Irfanview) in eCabinets. After opening the image click on image on the menu bar then choose enhance colors.
You can adjust the brightness and contrast here but I have had better luck using the Gamma Correction.
Enter a Gamma Correction value of 1.25 to 1.3 and that usually lightens the picture enough.
Just play with these controls till you get the result you want.
Kerry
I like to save the images as jpegs then open them using the image control (Irfanview) in eCabinets. After opening the image click on image on the menu bar then choose enhance colors.
You can adjust the brightness and contrast here but I have had better luck using the Gamma Correction.
Enter a Gamma Correction value of 1.25 to 1.3 and that usually lightens the picture enough.
Just play with these controls till you get the result you want.
Kerry
