Drilling holes for pulls

BenRatt · Post by **BenRatt** » Wed, Jan 24 2007, 8:33AM

I know how to place pulls on the cabinet doors and drawers, but is there a way to have the holes drilled for the hardware on the router? I can't get it to work. I know you could do it in part editor but I was hoping for an easier way. Thanks

DanEpps · Post by **DanEpps** » Wed, Jan 24 2007, 8:36AM

Do you have hole patterns associated with the hardware?

Forrest Chapman · Post by **Forrest Chapman** » Wed, Jan 24 2007, 8:55AM

Ben,

No, you'll just have to you part edit for now and constrain the holes.

Forrest

BenRatt · Post by **BenRatt** » Wed, Jan 24 2007, 11:28AM

Well, I tried this and the part editor wouldn't let me edit an MDF door, so I guess I'm out of luck, huh?

Thermwood / eCabinet Systems

Drilling holes for pulls

Drilling holes for pulls