Hello again
Is there a way to put 2 handles on one drawer front?
drawer handles
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Jonathan Lester
- Senior Member
- Posts: 133
- Joined: Thu, May 25 2006, 9:29AM
- Location: Carleton Place, Ontario
-
Todd Miller
Yes you can!
Pull up you cabinet in the cabinet editor. Add your drawer(s)
First, go in to the door/drawer editor.
Next, click on the hardware selection tab
Choose your hardware. Make sure you choose the \"select as default
drawer pull\" tab. This will associate the pull to the drawer front.
Then, highlight the drawer face with a single click.
Next, click add/locate pulls.
Make sure you have the \"second drawer pull\" box checked.
Enter your values and hit ok.
Note: If you leave the location values set to center, and have the \"second drawer pull\" box checked, nothing will happen.
Pull up you cabinet in the cabinet editor. Add your drawer(s)
First, go in to the door/drawer editor.
Next, click on the hardware selection tab
Choose your hardware. Make sure you choose the \"select as default
drawer pull\" tab. This will associate the pull to the drawer front.
Then, highlight the drawer face with a single click.
Next, click add/locate pulls.
Make sure you have the \"second drawer pull\" box checked.
Enter your values and hit ok.
Note: If you leave the location values set to center, and have the \"second drawer pull\" box checked, nothing will happen.
