part editor depths

[Mark Hesketh]

is there any way to adjust the depth of a feature created in part editor without erasing and re-creating it? i have some features which are too deep and need to be raised, but don't really want to redraw it all if i don't have to.

[DanEpps]

In contour mode of the part editor, right-click and choose \"Create Edges\" then save the geometry to an x_t file.

Now you can remove the prior cuts and re-do them from the x_t file. Just open the file in contour mode and your geometry is placed in the same location as before.

[Mark Hesketh]

sweet! i will give that a try. thanks a bunch!