Bar Rail

Brian Shannon · Post by **Brian Shannon** » Sun, Feb 11 2007, 8:55PM

In order to machine the bar rail, I had to do the Top, then the Bottom separately. Otherwise, the bottom gave me errors in Profile Modeler. I also had to offset the bottom cutter by 2 1/2\". Let me know if there are any questions.

Brian

Brian Shannon · Post by **Brian Shannon** » Sun, Feb 11 2007, 9:05PM

More files

Zach Froble · Post by **Zach Froble** » Mon, Jan 19 2009, 5:52PM

Brian,

Do you still have the bar rail .tol files. I have a design I have to complete and need to model some radiused bar rail. The files from your original post are not there.

Thanks,
Zach

Brian Shannon · Post by **Brian Shannon** » Thu, Jan 22 2009, 12:44AM

Hey Zach,

Did the files I emailed to you work?

Brian

Zach Froble · Post by **Zach Froble** » Thu, Jan 22 2009, 9:23AM

Brian,

The files you send did work. Thank you again.

I am still trying to figure out what problem I was having creating the tool from my dxf. The one I drew resembled yours, but for some reason I kept getting an error when I tried to create the tool.

Zach

Kerry Fullington · Post by **Kerry Fullington** » Thu, Jan 22 2009, 9:41AM

Zach,

If your .dxf had any splines it won't work. Replace the splines with arcs.

Kerry

Brian Shannon · Post by **Brian Shannon** » Thu, Jan 22 2009, 10:25AM

Kerry is correct. I created my tool using splines and had to trace over the splines with arcs and lines to get it to work.

Zach Froble · Post by **Zach Froble** » Fri, Jan 23 2009, 5:20PM

Kerry and Brian,

I checked the dxf file and it seems to be all arches and straight lines. I posted the dxf in the ecabinets forum if you want to take a look at it.

Zach

Thermwood / eCabinet Systems

Bar Rail

Bar Rail

Re: Bar Rail

Re: Bar Rail

Re: Bar Rail

Re: Bar Rail

Re: Bar Rail

Re: Bar Rail