Shine on brass pipe

George Davidson · Post by **George Davidson** » Mon, Feb 12 2007, 11:08AM

I had to play with the shine in the room!

A bar I am makeing for my son I put the brass foot pipe
in the room. I used just one 6\" then all 12\" the 6\" and 12\" all
had shine. I had to play with the shine the 6\" has shine the 12\"
I can not get the shine back. What am I going wrong Help

George Davidson · Post by **George Davidson** » Mon, Feb 12 2007, 11:12AM

Her is the bar

Kerry Fullington · Post by **Kerry Fullington** » Wed, Feb 14 2007, 9:02AM

George,
After you render the view in Presentation View. Right click on the part and choose adjust shine and enter a value of 100. This would put the shine back.
Kerry

George Davidson · Post by **George Davidson** » Wed, Feb 14 2007, 10:46AM

Hi Kerry I tryed that put I just could not get it back right
I adjust shine 1 all the way up to 100
then tryed the apply dialog setting no luck
I gave up and took it back to the cabinet/assembly editor room
and went to match texture and match a brass leg.
That worked for me.It looks like the 6\" pipe is not
the same shine as the 12\"
I put just one 6\" pipe on the corner.
I am looking to make a cool bar it is for my sons basement
that is just a start I do not like it? This is what the back is going
to look like. Now I have to make it up in e-Cabinets