Grain problems in Nesting.

Leo Graywacz · Post by **Leo Graywacz** » Wed, Feb 14 2007, 11:15AM

I am starting to look at the outputs of the nesting from a job, and the parts are not arranged according to the grain direction. I have sides of cabinets the have the grain going the wrong way and it set the shelves up with the grain going from front to back instead of side to side. What do I need to correct this. It may work for non-grained items like melamine but not with my A1 Cherry ply. Thanks.

Thom Davies · Post by **Thom Davies** » Wed, Feb 14 2007, 1:10PM

Hey Leo

Make sure in your sheet stock that the A1 cherry ply has the grain box ticked, then that might sort out your problem

Thanks

Thom Davies

Leo Graywacz · Post by **Leo Graywacz** » Wed, Feb 14 2007, 1:13PM

I changed the orientation in the nest to vertical, that seemed to do it. We'll see as I do more jobs. I check the box anyway to make sure. Thanks Thom.

Michael S Murray · Post by **Michael S Murray** » Wed, Feb 14 2007, 1:31PM

Leo, also check that you havent turned your grain direction when building your cabinet. This would be in the cabinet editor under const. settings.

Michael S Murray · Post by **Michael S Murray** » Wed, Feb 14 2007, 1:31PM

Leo, also check that you havent turned your grain direction when building your cabinet. This would be in the cabinet editor under const. settings.

Thermwood / eCabinet Systems

Grain problems in Nesting.

Grain problems in Nesting.