5.1 Hole Problem

[Thom Davies]

Hey Hows it all going?

Installed 5.1 yesterday. Sent some cabinets down to the therm and this message came up in the cnc area about the screw holes i use.

(in blue bar) Inactive Item

(in grey box) A\\hardware\\KD Hardware\\wood technology\\WT-8051.001.061 in this job has been discontinused or is no longer available from the vendor!

If this item is in a room it will ONLY ne displayed! If this item existed on a cabinet it will be removed! this item will NOT be included in the \"buy list\" or \"dynamic Cost Calculations\"

Does this mean i need to apply a new screw to my hole patten?

Thanks

Thom Davies

[Todd Miller]

Thom,
It just sounds like you need to associate the hole pattern to a different piece of hardware. Then set the new hardware to your default.

[Thom Davies]

Sweet, thanks todd.