V5.1 Nest Diagram Feature Change/BUG?

[Scott Emmel]

I have notices a change in the Nest Diagrams after I upgraded to V5.1

I have some cabinets that I have added applied veneer to by adding a display panel from sheet stock that is 1/32\" thick ( 4' X 8' sheet).

In V5 when I created Nest Diagrams for a project, all of these display panels would nest on the 4' X 8' sheets I defined (as noted above).

In V5.1 none of these display panels nest anymore.

I have even filtered out all the parts except these panels and all I get is.
\"No Items to Nest\" or something like that. I can't remember the exact message I received.

Is there something new that has to be done in V5.1 in order to get these parts to nest?

Any help would be appreciated.

[Michael S Murray]

Hi Scott,
I beleive this is a known bug, as display panels are not nesting at the machine either. I have sent this to Scott and he is aware of it.

[Justin D Melhiser]

We are aware of this. If you have the panel associated to the cabinet it will not show up in the nest. If you disasssociate it from the cabinet it will show up in the nest. This will be taken care of. Thank You