Milling Aluminum
Moderators: Jason Susnjara, Clint Buechlein, Jason Susnjara, Clint Buechlein
-
Wade Huggins
- New Member
- Posts: 1
- Joined: Fri, Jan 12 2007, 4:25PM
Milling Aluminum
I'm trying to mill some offset fixtures out of aluminum plate and I've already gummed up one bit. What is a good bit, spindle speed, feed rate, and bite per pass for such an operation?
-
Roger Erismann
- Senior Member
- Posts: 169
- Joined: Sun, Dec 04 2005, 11:42PM
- Location: Sacramento, CA and Rolla, Mo
