Making miter cuts

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
User avatar
Roger Erismann
Senior Member
Posts: 169
Joined: Sun, Dec 04 2005, 11:42PM
Location: Sacramento, CA and Rolla, Mo

Making miter cuts

Post by Roger Erismann »

Whats the deal with making miter cuts? when I ask if it's possible in ecabs..the inevitable answer is no...but I see plenty of V groove and miter bits available for the CNC...

I made a \"miter tool\" and the profile modeler copied it...


This is reference doing 45 mitre on panels that would be assembled later...like returns on wall panles or large cases...
Wood Butcher/Case Maker
Top
Nemanja Vujkovic
Senior Member
Posts: 222
Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO

Post by Nemanja Vujkovic »

I was just tinking about this. It would be posible in Profile Modeler. The cnc operator woud probably have to set the bit as a costum bit. We coud probably try this next week !!! :D
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”