MDF Doors

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

MDF Doors

Post by Brian Shannon »

I've made MDF Doors in Profile Modeler. Now I have a need for a quick door. I bought a Whiteside 3750 bit. How do I make the router make two passes in a conventional direction so the cut is cleaner than just a single pass? Do I just make my tool dia. in tooling setup a little smaller than it is in eCab .tol ?



Brian
Top
User avatar
Roger Erismann
Senior Member
Posts: 169
Joined: Sun, Dec 04 2005, 11:42PM
Location: Sacramento, CA and Rolla, Mo

Post by Roger Erismann »

Brian...

That is what I was contemplating with a v groove bit...was gonna try it on monday...good luck
Wood Butcher/Case Maker
Top
Mark Taylor
Guru Member
Posts: 309
Joined: Sat, Feb 04 2006, 5:13PM
Location: Hilton Head / Bluffton SC

Post by Mark Taylor »

See Ryan's response to a similar question I had...

http://www.thermwood.com/forums/viewtopic.php?t=5258

Mark
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”