Problem with G-code!

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Wed, Apr 04 2007, 8:57AM

I just nested 2 different parts made out of same material and it nests good,but when i try to write CNC, an microsoft error pups up saying that THM application caused a problem.
After that i did the parts separately and it works great.

What canbe the problem???

Thank You!

Pete Riddle · Post by **Pete Riddle** » Wed, Apr 04 2007, 9:25AM

Nemanja,

What version of Control Nesting are you running on the SuperControl? If it is not the latest and greatest update to that and try again.

If it is the latest version you can send your twd/dxf parts to program@thermwood.com and we can have a look at the problem.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Wed, Apr 04 2007, 1:51PM

I have sent you a file!

Pete Riddle · Post by **Pete Riddle** » Thu, Apr 05 2007, 7:40AM

Nemanja,

The problem is definitely in the #3 part.

Thermwood / eCabinet Systems

Problem with G-code!

Problem with G-code!