5 Piece door

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Chris B Campbell
Senior Member
Posts: 114
Joined: Fri, Jul 29 2005, 4:00PM
Location: Helendale, CA.

5 Piece door

Post by Chris B Campbell »

Has anyone run this yet? Any comments? We spend a small fortune on door and drawer fronts so we are seriously looking at this option for our CS40.

Thanks
Chris
shoreline@dwisp.net
Top
Nemanja Vujkovic
Senior Member
Posts: 222
Joined: Wed, Feb 21 2007, 1:29PM
Location: STL, MO

Post by Nemanja Vujkovic »

We ran some, but we just did the panels, stiles and rails we ran on shaper!
Top
Todd Miller

Post by Todd Miller »

Chris,
We have been running them successfully at our trade shows. Although, you probably want comments from other customers. But, if you have any specific questions, feel free to ask!
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”