Print out quality- need help

Jeff Blewitt · Post by **Jeff Blewitt** » Thu, Apr 12 2007, 5:06PM

I seem to remember a while back someone had this issue and the fix was simple. Can anyone help me remember?

When I print the nesting diagrams and specifically the part detail sheets, I get red letters superimposed over black letters. It makes the diagrams completely unreadable.

Thanks!

Dave O Jeffries · Post by **Dave O Jeffries** » Fri, Apr 13 2007, 2:21PM

first time today black letters with red imposed over then green on sheet cutouts

Denis L'Heureux · Post by **Denis L'Heureux** » Fri, Apr 13 2007, 2:23PM

Dave O Jeffries wrote:first time today black letters with red imposed over then green on sheet cutouts

I had that before....I didn't do anything to fix it, it just went away on its own.

Todd Miller · Post by **Todd Miller** » Fri, Apr 13 2007, 2:27PM

Denis,
If you would like to post the job file you are trying to print I can take a look at it for you... Thanks!

Jeff Blewitt · Post by **Jeff Blewitt** » Fri, Apr 13 2007, 4:00PM

Todd,
Mine wasn't a Job File. It was a single cabinet. I have 44 of these to build for a wine store so I can't batch it or job file it (single part limit). But here's the file

Kerry Fullington · Post by **Kerry Fullington** » Fri, Apr 13 2007, 5:10PM

Jeff,
I tried your job and it displays and prints properly on my computer so I won't be much help.
Some problems have been reported where the cabinet name was too long and it caused the writing to run together. I didn't find this problem with yours.
You could try printing by \"view\" and use the shift key and both mouse buttons to zoom the sheet view before you print and see if that helps.
Just in case you are using a different version or build I am using version 5.1 build 2.
Sorry I couldn't be more help.
Kerry

Jeff Blewitt · Post by **Jeff Blewitt** » Fri, Apr 13 2007, 6:21PM

Kerry,

Everything just seems to work better for you

Want a Job? I'm using the same version and interstingly enough I had this problem originally, then it went away with an update. Now since I updated to build 2 it showed up again. What it looks like is if you print the sheets, then run them back through the printer with the same information but in a different color. Everything is offset a millimeter or two. Just enough to make it unreadable. Wonder if it could be a print driver or something?

Kerry Fullington · Post by **Kerry Fullington** » Fri, Apr 13 2007, 6:24PM

Jeff,
I think I would try the latest print drivers. Set a restore point in case it causes more problems then you can go back.
Kerry

Denis L'Heureux · Post by **Denis L'Heureux** » Mon, Apr 16 2007, 9:54AM

Todd Miller wrote:Denis,
If you would like to post the job file you are trying to print I can take a look at it for you... Thanks!

As I said, it just fixed itself. I have had this issue a few times in the late v4 builds. Saved the file and sometimes it was fixed the next time I opened it and sometimes not.

No issues anymore though lately.

Todd Miller · Post by **Todd Miller** » Mon, Apr 16 2007, 2:26PM

Mine seems to be working fine as well. Try just nesting 1 cabinet, then see if you get the same results. This might have to do with the number a parts you are nesting.

Thermwood / eCabinet Systems

Print out quality- need help

Print out quality- need help

same thing happened to me

Re: same thing happened to me

Re: