End Panels

Leo Graywacz · Post by **Leo Graywacz** » Tue, May 01 2007, 10:14PM

Is it possible to put a framed glass end panel (or door) on an upper corner cabinet. If so how. Thank you.

mikesand · Post by **mikesand** » Tue, May 01 2007, 10:32PM

Yes, install a door and choose the glass option in the door detail dialogue.

Michael Yeargain · Post by **Michael Yeargain** » Wed, May 02 2007, 5:39AM

Leo,

from the detail room select the cabinet and right click, adjust cabinet features, cabinet end (S,J,C) select the left, right or both sides radio button make adjustments if needed to the insets, select the door you want click ok...

This will put a end panel on the cabinet. But if you want the end panel to replace the left or right sides you will need to do so in the cabinet editor and align them accordingly.

Leo Graywacz · Post by **Leo Graywacz** » Wed, May 02 2007, 6:50AM

This is the error I get when I do that

Michael Yeargain · Post by **Michael Yeargain** » Wed, May 02 2007, 2:36PM

Leo,

I appologize fro not reading carefully. You asked about corner cabinets. They are not supported. You will have to take the cabinet into the editor and add the door there. Don't forget to associate the door to the cabinet before you save the file.

Mike Sand is correct about the settings in the door dialog.