I cant seem to be able to get the left or right door gaps to change on a frameless angled front corner cabinet. Eg take the standard base frameless corner cabinet into the door editor go to add left hinged door without changing any settings and i get a door that is 431mm wide, do the same thing and change the left and right gaps to 20 and the door is still 431 wide.
Is it just me or am i missing something here?
John
angle front corner cabinet
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
John Lawrence
- Junior Member
- Posts: 76
- Joined: Fri, Dec 16 2005, 5:52AM
- Contact:
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Angled Front Corner Cabinet
John,
I did a quick test here on my system and it appears that neither the Left/Right Gaps (if the Door/Drawer is inset) or the Left/Right Reveals work on my system. (The Top and Bottom Gaps/Reveals seem to \"respond\".)
Hmmmm..... Anyone else?
I did a quick test here on my system and it appears that neither the Left/Right Gaps (if the Door/Drawer is inset) or the Left/Right Reveals work on my system. (The Top and Bottom Gaps/Reveals seem to \"respond\".)
Hmmmm..... Anyone else?
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
CORRECTION - Angled Front Corner Cabinet
Please forgive me...
It appears that I was way to quick on my analysis...
I made the mistake to not RETURN to the MAIN Cabinet Editor area to review the results of my settings. It seems that the Left and Right Reveals/Gaps are not recalculated until you return to the main area of the Cabinet Editor.
When I included this all important step, my dimensions were being adjusted according to my Reveal and/ or Gap settings.
Again... sorry.
John - Are your dimension issues perhaps related to the same thing? Are you trying to check your door widths prior to returning to the Main Cabinet Editor area?
It appears that I was way to quick on my analysis...
I made the mistake to not RETURN to the MAIN Cabinet Editor area to review the results of my settings. It seems that the Left and Right Reveals/Gaps are not recalculated until you return to the main area of the Cabinet Editor.
When I included this all important step, my dimensions were being adjusted according to my Reveal and/ or Gap settings.
Again... sorry.
John - Are your dimension issues perhaps related to the same thing? Are you trying to check your door widths prior to returning to the Main Cabinet Editor area?