Quadro Tweak Utility and Build 3

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
User avatar
Al Navas
eCabinets Beta Tester
Posts: 443
Joined: Fri, Feb 17 2006, 5:22AM
Location: Near St Joseph, Missouri, USA
Contact:
Contact Al Navas

Quadro Tweak Utility and Build 3

Post by Al Navas »

Is it necessary to re-run the Quadro tweak utility after installing Build 3?


.
Al
http://sandal-woodsblog.com
Sandal Woods - Fine Woodworking
Top
User avatar
Dean Fehribach
Site Admin
Posts: 423
Joined: Mon, May 09 2005, 2:10PM
Company Name: Thermwood Corporation
Country: UNITED STATES
Location: Thermwood

Post by Dean Fehribach »

No, but re-running doesn't hurt (but doesn't help, either). The Quadro Tweak Utility puts information into nVidia's section of the registry where eCabinet Systems installs and upgrades don't write.

Curiously, why do you ask?
Dean Fehribach
I.S. Mgr., Thermwood
Dell Workstation T1650 / XEON E3 / 8GB RAM / 1GB nVidia Quadro 600 / Windows 8 Pro x64
Top
User avatar
Al Navas
eCabinets Beta Tester
Posts: 443
Joined: Fri, Feb 17 2006, 5:22AM
Location: Near St Joseph, Missouri, USA
Contact:
Contact Al Navas

Post by Al Navas »

Thanks, Dean.

I ask because I am being VERY cautious and will do ONLY what is recommended, after someone has tried it out. I did not want to run the utility after installing Build 3 if it was going to cause unexpected or unsuspected problems, Dean.
Al
http://sandal-woodsblog.com
Sandal Woods - Fine Woodworking
Top
Post Reply

Return to “eCabinet Systems Software”