Help Please

Zach Froble · Post by **Zach Froble** » Thu, May 10 2007, 6:30PM

I am having some problems, which are yet to be resolved. I know a lot of the members that don't have machines don't check the \"Thermwood\" forum that often, but I would appreciate you guys taking a look at my posts there to see if anyone else has ran into this before.

I appreciate any help.

Thanks,

Zach

Walker T Scott · Post by **Walker T Scott** » Fri, May 11 2007, 6:09AM

Zach

Could you attach one of the problem cabinets in this post so we can take a look at it?
Thanks
Walker

Geo Noeth · Post by **Geo Noeth** » Fri, May 11 2007, 6:21AM

Zack,

What posts are you referring to I do not see anything on this page.

Walker T Scott · Post by **Walker T Scott** » Fri, May 11 2007, 6:27AM

Geo

Zach original post is in the Thermwood forum.

http://www.thermwood.com/forums/viewtopic.php?t=5733

Zach Froble · Post by **Zach Froble** » Fri, May 11 2007, 7:53AM

Walker,

I sent all the files and info to program@thermwood yesterday.

Thanks,

Zach

Scott G Vaal · Post by **Scott G Vaal** » Fri, May 11 2007, 10:11AM

Zach,

I want to get to the bottom of this for you! I am looking at your \"Diperna\" job and the nest looks correct in eCabinets and also looks ok for me at control nest (first glance anyway). Would it be possible for you to pin point one of the cabinets that presents this problem? That would help me narrow it down faster.

Are you running the latest eCabinets and Control nesting? If you would like to talk about this over the phone, it may speed up the process of figuring this out. Feel free to call me @ 1-800-533-6901 ask for Scott.