Is there any way that we could regain the ability to apply edgebanding with a 0\" thickness? We use a pre-mill on our edgebander, so I don't need to account for the thickness of the banding. However, the guys found it very helpfull to see the diagram showing them which side was to be edged. It is especially helpful when we get a junior guy helping out.
Does this even interest anybody else, or is it just me?
edgebanding request
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Mark Hesketh
- Guru Member
- Posts: 366
- Joined: Fri, Aug 25 2006, 9:12AM
- Company Name: Paris Kitchens
- Country: CANADA
- Location: Paris, ontario
-
Michael Yeargain
- eCabinets Beta Tester
- Posts: 1740
- Joined: Tue, May 17 2005, 8:33PM
- Company Name: Timeless Cabinetry and Mantles
- Location: South East
-
Nemanja Vujkovic
- Senior Member
- Posts: 222
- Joined: Wed, Feb 21 2007, 1:29PM
- Location: STL, MO
-
Michael Yeargain
- eCabinets Beta Tester
- Posts: 1740
- Joined: Tue, May 17 2005, 8:33PM
- Company Name: Timeless Cabinetry and Mantles
- Location: South East
Nemanja,
I also do that but, the problem here-in is the doors and fronts with this edgebanding results in slower performance.
At least it has in the past. I just make my doors from MDF and applied the appropriate wood grain.
I also do that but, the problem here-in is the doors and fronts with this edgebanding results in slower performance.
At least it has in the past. I just make my doors from MDF and applied the appropriate wood grain.
Intel Core i7-5820K (6-Cores, 3.3GHz, 15MB Cache)
32Gigs DDR4
NVIDIA GeForce GTX 960 4GB
SSD 840 256Gig, 2TB, 3TB, Samsung (2TB)
Corsair RM650
32Gigs DDR4
NVIDIA GeForce GTX 960 4GB
SSD 840 256Gig, 2TB, 3TB, Samsung (2TB)
Corsair RM650
