why can't dovetails work right?

Mark Hesketh · Post by **Mark Hesketh** » Tue, May 22 2007, 3:15PM

ne wproblem with the dovetail drawers. ran a batch today and lost all my parts with male dovetails on both ends. it is cutting the dovetails, then runs the outline pass down one side... but then it drops the outline tool down cutting off half of the end dovetail, like a drill operation, before running the outline down the other side (and it still is not leaving a skin on these passes). so now all my drawers have one part missing since the fronts all have male dovetails on both ends. what do i have to do to re-cut these so they will work?

i am using CN 5.28

Todd Miller · Post by **Todd Miller** » Wed, May 23 2007, 8:13AM

Mark,
I have just emailed you. I need a few pieces of information from you so we can get to the bottom of this. Thanks!

Mark Hesketh · Post by **Mark Hesketh** » Wed, May 23 2007, 8:40AM

Thanks Todd. Got your email and have sent the files you wanted in an email back to you.

Mark Taylor · Post by **Mark Taylor** » Wed, May 23 2007, 10:31PM

Todd,

Please post any info if you have it...I'm getting ready to run another batch of drawers either tomorrow or Friday and would love to not have any problems.

Todd Miller · Post by **Todd Miller** » Thu, May 24 2007, 8:30AM

Our guys are looking into this as we speak. As soon as we know something, we will let everybody know. Thanks for your patience.

Todd Miller · Post by **Todd Miller** » Thu, May 24 2007, 1:45PM

We have just released a CN update that should take care of this issue.

Mark Hesketh · Post by **Mark Hesketh** » Thu, May 24 2007, 3:12PM

HUZZAH!

just applied the new CN update and ran a batch of drawers... and as far as I can tell, it ran them perfectly! Thanks guys!

Mark Taylor · Post by **Mark Taylor** » Thu, May 24 2007, 6:35PM

Great!

I've got a set to run tomorrow...looking forward to it!

Mark

Thermwood / eCabinet Systems

why can't dovetails work right?

why can't dovetails work right?