Edgebanding logo an stickers for backs

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Ryan Osburn
New Member
Posts: 3
Joined: Fri, Mar 16 2007, 3:43PM

Edgebanding logo an stickers for backs

Post by Ryan Osburn »

Iam getting the edgebanding logo on cabnets and drawers for there backs even though I dont have edgebanding on any part of the drawer. its not all of them it seems to be just evry now and then why?
Attachments
Picture 004.jpg
Picture 004.jpg (154.67 KiB) Viewed 2931 times
Top
Todd Miller

Post by Todd Miller »

Ryan,
Have you checked in the Edgebanding editor to see if the edgebanding has been applied to those areas or not? If so, post the cabinet and we can take a look at it. Thanks!

Also, what version of Control Nesting are you running?
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”