design challenge

Jeff Blewitt · Post by **Jeff Blewitt** » Wed, May 30 2007, 2:06PM

Ok I know one of you guys is going to fire back \"Too Easy Sarg!\" but,....... I had a request for a ROUND table with a SCALLOPED apron that needs to be done ASAP. I'm having trouble figuring out how to make the apron with scallops. A little help please?

Thanks,

Mike Seisser · Post by **Mike Seisser** » Wed, May 30 2007, 3:06PM

Dimensions please?

Mike

Jeff Blewitt · Post by **Jeff Blewitt** » Wed, May 30 2007, 3:26PM

Here's what I have so far. The apron needs to scallop with the high points at the center of each leg

Kerry Fullington · Post by **Kerry Fullington** » Wed, May 30 2007, 3:55PM

This technique would need some cleaning up but it can be done.
Kerry

Al Navas · Post by **Al Navas** » Wed, May 30 2007, 4:02PM

Kerry Fullington wrote:This technique would need some cleaning up but it can be done.
Kerry

29 minutes! AND with a TRS-80 to boot...

Jeff Blewitt · Post by **Jeff Blewitt** » Wed, May 30 2007, 4:03PM

Yep, That's it Kerry! Now, how'd you do it?

Thanks,

Michael Yeargain · Post by **Michael Yeargain** » Wed, May 30 2007, 4:12PM

Jeff Blewitt wrote:Yep, That's it Kerry! Now, how'd you do it?

Thanks,

Wouldn't you like to know...?

Oh, I forgot, he's the one with the TSR 80. Surely bet he can show you how its done in a hurry.

Jeff Blewitt · Post by **Jeff Blewitt** » Wed, May 30 2007, 4:20PM

And your point is,...............??... Michael?

Kerry Fullington · Post by **Kerry Fullington** » Wed, May 30 2007, 6:34PM

Jeff,
Attached is your table with the apron cut and the tool I used to do it.
I created a tool to cut the scallops and defined intersecting tool paths in contour to guide the tool to cut the scallops. I changed the name of the assembly file so that it won't overwrite your original
Kerry

Michael Yeargain · Post by **Michael Yeargain** » Wed, May 30 2007, 6:57PM

See Jeff,

There's my point. All roads point to Kerry.

Kerry, Kerry he's our man...If he can't do it no one can

That's what I love about this place. Such a nice place to live...

Can't get this kind of service and advice from any other software out there.

Kerry Fullington · Post by **Kerry Fullington** » Wed, May 30 2007, 7:06PM

Now if I could just figure out how to put a profile on the scallops.
Kerry

Michael Yeargain · Post by **Michael Yeargain** » Wed, May 30 2007, 7:07PM

Kerry,

I wouldn't put anything past you... If it can be done...

Jeff Blewitt · Post by **Jeff Blewitt** » Thu, May 31 2007, 1:04PM

Kerry,
You're awsome. once again you pulled me out of a pinch and taught me something new all at the same time! You MUST be sick of hearing that by now

. Anyway, Thanks again! Hopefully I can return the favor.

By the way, I tried that coffee you suggested in another post. All I can say is that stuff must be made specifically for e-cabs super heros. Brewed up great, & smelled wonderful. But when I took the 1st sip it bit me right back!

Thanks,

Thermwood / eCabinet Systems

design challenge

design challenge

here's what I have

Re:

Re: