quick question on dadoes

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Mark Hesketh
Guru Member
Posts: 366
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

quick question on dadoes

Post by Mark Hesketh »

i have not been able to find the pattern with dadoes... some start at the end of a dado, some start in the middle. is there a reasoning behind the starting location?
Top
Ryan Hochgesang

Post by Ryan Hochgesang »

Hi Mark,

Control nesting takes the best rout it see's fit, while also trying to implement the Ramp value in the SETTINGS dialigue. This why on shorter dados it will likely start on either end, then on longer dados it may start in middle.
Top
Mark Hesketh
Guru Member
Posts: 366
Joined: Fri, Aug 25 2006, 9:12AM
Company Name: Paris Kitchens
Country: CANADA
Location: Paris, ontario

Post by Mark Hesketh »

sounds reasonable :) thanks
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”